Home › Vehicle Exterior › DOOR / HATCH › HOOD
RM38G0E _59 Vehicle Exterior _100887 DOOR / HATCH _0468187 HOOD A

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

HINT:
·
B360727C04
0.719,0.281 1.031,0.438 0.313,0.156 10 false *a 2.51,0.281 2.823,0.438 0.313,0.156 10 false *b
*a Centering Bolt
*b Standard Bolt


Centering bolts are used to install the hood hinges and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts with washers when making adjustments.

·

The specified torque for standard bolts is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure below is for LHD vehicles.



PROCEDURE

Hide 53301 1.INSPECT HOOD SUB-ASSEMBLY

Hide 53301 2.ADJUST HOOD SUB-ASSEMBLY

a.

Horizontally and vertically adjust the hood.

B620296

i.

Loosen the 4 hinge bolts of the hood.


ii.

Adjust the clearance between the hood and front fenders by moving the hood.


iii.

Tighten the 4 hinge bolts after adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)



b.
B609545

Adjust the height of the front end of the hood using the hood bumper cushions.

i.

Adjust the 2 hood bumper cushions so that the heights of the hood and fenders are aligned.

HINT:

Raise or lower the front end of the hood by turning the 2 hood bumper cushions.




c.

Adjust the hood lock.

i.
B618610

w/ Grill Shutter

1. Remove the 2 clips.

2. Move to forward and down, It able to use a Service Tools.

3. Loosen the 3 bolts.

4. Adjust the hood lock assembly and tighten the 3 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

5. Check that the striker can engage the hood lock assembly smoothly.


ii.
B618611

w/o Grill Shutter

1. Loosen the 3 bolts.

2. Adjust the hood lock assembly and tighten the 3 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

3. Check that the striker can engage the hood lock assembly smoothly.