Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT
RM38G0E _59 Vehicle Exterior _100887 DOOR / HATCH _0468188 HOOD SUPPORT A

DOOR / HATCH  HOOD SUPPORT  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B610682N05
4.625,1.927 6.135,3.24 1.51,1.313 5.021,3.021 5.188,3.021 5.188,3.021 5.323,2.719 false 5.844,1.24 5.979,1.063 5.979,1.063 6.146,1.063 false 4.813,2.854 5.094,3.208 0.281,0.354 18 false 1 6.448,0.896 6.729,1.25 0.281,0.354 18 false 2 4.698,1.979 5.073,2.219 0.375,0.24 12 false *A

Procedure Part Name Code
Z101186

Z101188

Z101187

1 ENGINE SIDE COVER 51474B - - -
2 HOOD SUPPORT ASSEMBLY 53450A (Click here) - -

*A except 1GR-FE - -

CAUTION / NOTICE / HINT

·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.


PROCEDURE

Hide 51474B 1.REMOVE AND INSTALL ENGINE SIDE COVER (except 1GR-FE)

a.
B611074


Hide 53450A 2.REMOVE HOOD SUPPORT ASSEMBLY

Z101186

CAUTION:
·
B611129

Do not perform work if the hood is not securely supported.

·

The hood could fall, resulting in injury.



NOTICE:
·

Avoid touching the piston rod as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any horizontal load to the hood support assembly in order to prevent the piston rod from deforming.




a.
B607533N01
1.729,0.052 2.146,0.333 0.417,0.281 18 true i, ii

i.

Use a screwdriver with its tip wrapped protective tape, slightly raise the 2 stop rings as shown in the illustration.

NOTICE:
·

Do not remove the stop rings from the hood support assembly. Raise the stop rings just enough to allow the ball joints to be disengaged.

·

Do not reuse the hood support assembly if a stop ring has been removed.




ii.

Disengage the 2 ball joints to remove the hood support assembly.

NOTICE:

Remove the hood support assembly while supporting the hood by hand.