Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR WARNING BUZZER
RM38G0E _59 Vehicle Exterior _100887 DOOR / HATCH _0468202 POWER BACK DOOR WARNING BUZZER A

DOOR / HATCH  POWER BACK DOOR WARNING BUZZER  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B610724N01
4.823,0.448 5.156,0.448 false 1.781,0.469 2.052,0.469 false 5.719,1.417 6.052,1.417 false 6.104,1.24 6.385,1.594 0.281,0.354 18 false 1 5.208,0.26 5.49,0.615 0.281,0.354 18 false 2 2.333,0.354 2.615,0.708 0.281,0.354 18 false 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 REAR BUMPER ASSEMBLY - - - -
2 REAR BUMPER ENERGY ABSORBER 52615 - - -
3 POWER BACK DOOR WARNING BUZZER 89747E - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the power back door warning buzzer removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)
Kick door control sensor Reset connection history There are cases where the connection history display differs from the vehicle condition. (Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function when Necessary Procedure not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -




PROCEDURE

Hide 89747E 3.REMOVE POWER BACK DOOR WARNING BUZZER

a.
B616848