| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 6 | WIRING HARNESS SUPPORT | 82712L | - | - | - |
| 7 | FRONT SEATBACK ASSEMBLY LH | - | - | - | - |
| 8 | RECLINING COVER PROTECTOR LH | 72554L | - | - | - |
| *A | w/o Rear Seat Entertainment System | *B | w/ Rear Seat Entertainment System |
| *C | w/ Front Seat Side Airbag | - | - |
| *A | w/ Rear Seat Entertainment System | - | - |
| *1 | FRONT SEAT HEADREST SUPPORT | - | - |
| *A | w/ Felt | *B | w/ Climate Control Seat System |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat assembly removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
|
|
2.REMOVE FRONT SEAT ASSEMBLY LH
82712L 6.REMOVE WIRING HARNESS SUPPORT
7.REMOVE FRONT SEATBACK ASSEMBLY LH
72554L 8.REMOVE RECLINING COVER PROTECTOR LH
71776B 10.REMOVE FRONT NO. 1 SEATBACK BOARD COVER (w/ Rear Seat Entertainment System)
71705G 11.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Rear Seat Entertainment System)
86680A 12.REMOVE TELEVISION DISPLAY ASSEMBLY (w/ Rear Seat Entertainment System)
72760G 14.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH
|
|
|
Remove in this Direction | - | - |
79977N 15.REMOVE SEATBACK FELT (w/ Felt)
85867G 16.REMOVE SEATBACK CLIMATE CONTROL BLOWER LH (w/ Climate Control Seat System)
71587L 17.REMOVE FRONT SEATBACK EDGE PROTECTOR LH