| *A | for Driver Side | *B | for Passenger Side |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 7 | WIRING HARNESS SUPPORT | 82712L | - | - | - |
| 8 | FRONT SEATBACK ASSEMBLY LH | - | - | - | - |
| *A | w/o Rear Seat Entertainment System | *B | w/ Rear Seat Entertainment System |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 9 | SEAT CUSHION COVER WITH PAD | - | - | - | - |
| 10 | FRONT SEAT CUSHION COVER SUB-ASSEMBLY LH | 71072 | ( ) |
- | - |
| 11 | FRONT SEAT CUSHION HEATER ASSEMBLY LH | 87511D | ( ) |
- | - |
| *1 | FRONT SEAT CUSHION PAD LH | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat assembly removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1. PRECAUTION
|
|
2.REMOVE FRONT SEAT ASSEMBLY LH
82712L 7.REMOVE WIRING HARNESS SUPPORT
8.REMOVE FRONT SEATBACK ASSEMBLY LH
9.REMOVE SEAT CUSHION COVER WITH PAD
87511D 11.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH
Remove the tape and front cushion heater assembly LH.
Do not reuse the front cushion heater assembly LH.
If the front cushion heater assembly LH is removed from the front seat cushion pad LH, replace the front seat cushion pad LH with new one.