| *A | w/ Child Restraint System Guide | *B | w/o Child Restraint System Guide |
| *C | w/o Wire Harness | - | - |
| *1 | REAR NO. 1 SEAT CUSHION PAD RH | *2 | HOG RING |
| ● | Non-reusable part | - | - |
| *A | w/ Wire Harness | *B | w/ Child Restraint System Guide |
| *1 | NO. 1 SEATBACK PAD RH | *2 | SPRING NUT |
| *3 | NO. 1 SEAT CUSHION FRAME SUB-ASSEMBLY RH | *4 | HOG RING |
| *5 | PLATE WASHER | - | - |
| ★ | Precoated part | ● | Non-reusable part |
71834S 1.REMOVE REAR NO. 1 SEAT RECLINING COVER LH
|
Remove in this Direction | - | - |
Using moulding remover D, detach the clip, claw and guide as shown in the illustration.
Using moulding remover D, detach the claw and guide as shown in the illustration.
Using moulding remover D, detach the claw and guide as shown in the illustration.
Using moulding remover D, detach the claw and guide as shown in the illustration.
Detach the guide and remove the rear No. 1 seat reclining cover LH as shown in the illustration.
72329F 2.REMOVE REAR SEAT ADJUSTER BOLT COVER
72525R 3.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
71833S 4.REMOVE REAR NO. 1 SEAT RECLINING COVER RH
|
Place Hand Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) | - | - |
Follow the procedure below to detach the claw, clip and guide.
1. Place your hand at the position shown in the illustration and pull in the removal direction (1) to detach the clip, claw and guide.
2. Place your hand at the position shown in the illustration and pull in the removal direction (2) to detach the claw and guide.
|
Place Hand Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Remove in this Direction (3) |
Follow the procedure below to remove the rear No. 1 seat reclining cover RH.
1. Place your hand at the position shown in the illustration and pull in the removal direction (1) to detach the claw.
2. Place your hand at the position shown in the illustration and pull in the removal direction (2) to detach the claw and guide.
3. Place your hands at the position shown in the illustration and pull in the removal direction (3) to detach the guide and remove the rear No. 1 seat reclining cover RH.
78950F 5.REMOVE NO. 1 FOLD SEAT STOPPER BAND ASSEMBLY
|
Open in this Direction | - | - |
76971G 6.REMOVE REAR UNDER COVER
79952A 7.REMOVE NO. 1 SEAT NO. 2 CUSHION COVER
|
Remove in this Direction | - | - |
79951B 8.REMOVE NO. 1 SEAT NO. 1 CUSHION COVER
|
Remove in this Direction | - | - |
79967W 9.REMOVE REAR NO. 1 SEAT NO. 4 LEG SIDE COVER
|
Remove in this Direction | - | - |
Use the same procedure for the other side.
82193 10.REMOVE REAR SEAT WIRE RH (w/o Wire Harness)
|
Remove in this Direction | - | - |
71302C 11.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH
71301G 12.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH
| *A | w/ Wire Harness | - | - |
|
Remove in this Direction | - | - |
72995F 13.REMOVE REAR SEAT CUSHION COVER RH
72927F 14.REMOVE REAR SEAT CUSHION UNDER COVER RH
73350 15.REMOVE REAR CENTER SEAT LAP TYPE BELT ASSEMBLY
73380C 16.REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY RH
73310D 17.DISCONNECT REAR CENTER SEAT 3 POINT TYPE BELT ASSEMBLY (SEAT ANCHOR)
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
72996H 18.REMOVE REAR SEATBACK COVER (w/ Child Restraint System Guide)
|
Remove in this Direction | - | - |
71701A 19.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY RH
20.REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY RH
|
Remove in this Direction | - | - |
71075F 21.REMOVE NO. 1 SEAT CUSHION COVER SUB-ASSEMBLY RH
|
|
| *A | w/ Child Restraint System Guide | *B | w/o Child Restraint System Guide |
|
Fastener | - | - |
w/ Child Restraint System Guide:
1. Remove the 12 hog rings and 2 fasteners.
w/o Child Restraint System Guide:
1. Remove the 8 hog rings.
Using a thin-bladed screwdriver, detach the claw to remove the No. 1 seat cushion cover sub-assembly LH from the rear No. 1 seat cushion pad LH as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
73178A 22.REMOVE SEAT BELT ANCHOR COVER CAP
73373 23.REMOVE REAR SEAT SHOULDER BELT COVER
|
Remove in this Direction | - | - |
71930Q 24.REMOVE REAR SEAT HEADREST SUPPORT ASSEMBLY
25.REMOVE SEPARATE TYPE REAR SEATBACK ASSEMBLY RH
|
Remove in this Direction | - | - |
79013D 26.REMOVE NO. 1 SEATBACK COVER SUB-ASSEMBLY RH
|
|
Remove the 6 hog rings.
Using a thin-bladed screwdriver, detach the claw to remove the No. 1 seatback cover sub-assembly RH from the No. 1 seatback pad RH as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
73310D 27.REMOVE REAR CENTER SEAT 3 POINT TYPE BELT ASSEMBLY
79117D 28.REMOVE NO. 1 SEAT CUSHION CARPET (w/ Child Restraint System Guide)
| *a | Fastener | - | - |
|
Remove in this Direction | - | - |
71694G 29.REMOVE REAR INNER SEAT CUSHION HINGE COVER LH
71485E 30.REMOVE REAR SEAT HINGE COVER
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Remove in this Direction (3) | - | - |
Follow the procedure below to remove the rear seat hinge cover.
1. Pull in the removal direction (1) to detach the claw and guide as shown in the illustration.
2. Pull in the removal direction (2) to detach the claw and guide as shown in the illustration.
3. Pull in the removal direction (3) to detach the guide and remove the rear seat hinge cover as shown in the illustration.
71H76L 31.REMOVE SEAT RECLINING ADJUSTER INSIDE COVER RH
71H75L 32.REMOVE SEAT RECLINING ADJUSTER INSIDE COVER RH
72552K 33.REMOVE SEAT RECLINING HINGE COVER RH
72551M 34.REMOVE SEAT RECLINING HINGE COVER RH
72569B 35.REMOVE SEATBACK STOPPER PLATE
71486F 36.REMOVE REAR SEAT HINGE COVER LH
79103B 37.REMOVE NO. 1 SEATBACK FRAME SUB-ASSEMBLY RH
| *a | Cable End | - | - |
|
Remove in this Direction |
|
Bolt |
|
"TORX" Bolt | - | - |
Detach each casing cap.
Turn each cable end in the removal direction shown in the illustration and disconnect the cable end.
Remove the 3 bolts.
Using a T55H wrench torx for tamper resistant, remove the 2 "TORX" bolts and No. 1 seatback frame sub-assembly RH.
72307D 38.REMOVE NO. 1 RECLINING CONTROL LINK SUB-ASSEMBLY RH
71461H 39.REMOVE REAR SEAT CUSHION SPRING
Use the same procedure for the other side.
72143D 40.REMOVE REAR SEAT LOWER TRACK BRACKET RH
72660P 41.REMOVE REAR SEAT LOCK ASSEMBLY LH
| *a | Cable End | - | - |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Detach the casing cap.
Turn the cable end in the removal direction (1) shown in the illustration and disconnect the cable end.
Slide in the removal direction (2) shown in the illustration to remove the rear seat lock assembly LH.
72650J 42.REMOVE REAR SEAT LOCK ASSEMBLY RH
| *a | Cable End | - | - |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Remove the nut and plate washer.
Detach the casing cap.
Turn the cable end in the removal direction (1) shown in the illustration and disconnect the cable end.
Slide in the removal direction (2) shown in the illustration to remove the rear seat lock assembly RH.
72570E 43.REMOVE NO. 1 SEAT RECLINING ADJUSTING CABLE ASSEMBLY RH
78910C 44.REMOVE SEAT FOLD SEAT LOCK CONTROL CABLE ASSEMBLY RH
82193 45.REMOVE REAR SEAT WIRE RH (w/ Wire Harness)
The illustrations are representative examples, and details may differ.