| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | REAR NO. 1 SEAT ASSEMBLY RH | - | - | - | - |
| *A | w/ Child Restraint System Guide | - | - |
| *1 | NO. 1 SEATBACK PAD RH | *2 | HOG RING |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear seatback heater assembly RH removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Move both front seats to the frontmost position and fold them forward.
1.REMOVE REAR NO. 1 SEAT ASSEMBLY RH
72329F 3.REMOVE REAR SEAT ADJUSTER BOLT COVER
72525R 4.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
78950F 6.REMOVE NO. 1 FOLD SEAT STOPPER BAND ASSEMBLY
79952A 7.REMOVE NO. 1 SEAT NO. 2 CUSHION COVER
79951B 8.REMOVE NO. 1 SEAT NO. 1 CUSHION COVER
79967W 9.REMOVE REAR NO. 1 SEAT NO. 4 LEG SIDE COVER
71302C 10.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH
71301G 11.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH
72995F 12.REMOVE REAR SEAT CUSHION COVER RH
72927F 13.REMOVE REAR SEAT CUSHION UNDER COVER RH
73380C 14.REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY RH
73310D 15.DISCONNECT REAR CENTER SEAT 3 POINT TYPE BELT ASSEMBLY (SEAT ANCHOR)
72996H 16.REMOVE REAR SEATBACK COVER (w/ Child Restraint System Guide)
71701A 17.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY RH
73178A 18.REMOVE SEAT BELT ANCHOR COVER CAP
73373 19.REMOVE REAR SEAT SHOULDER BELT COVER
71930Q 20.REMOVE REAR SEAT HEADREST SUPPORT ASSEMBLY
21.REMOVE SEPARATE TYPE REAR SEATBACK ASSEMBLY RH
87530A 23.REMOVE REAR NO. 1 SEATBACK HEATER ASSEMBLY RH
Remove the tape and the rear No. 1 seatback heater assembly RH.
Do not reuse the rear No. 1 seatback heater assembly RH.
If the rear No. 1 seatback heater assembly RH is removed from the No. 1 seatback pad RH, replace the No. 1 seatback pad RH with new one.