Home › Vehicle Interior › SEAT › SEAT HEATER CONTROL (for 40/20/40 Split Seat Type RH Side)
RM38G0E _58 Vehicle Interior _100628 SEAT _0468272 SEAT HEATER CONTROL(for 40/20/40 Split Seat Type RH Side) A

SEAT  SEAT HEATER CONTROL(for 40/20/40 Split Seat Type RH Side)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B622144N01
4.042,1.042 4.656,1.042 false 4.719,0.875 5,1.229 0.281,0.354 18 false 1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 REAR NO. 1 SEAT ASSEMBLY RH - - - -

B622152N02
3.906,2.688 4.521,2.688 false 2.563,1.302 3.323,1.302 false 2.406,0.708 2.969,0.708 false 3.771,0.24 4.094,0.24 false 6.396,3.719 6.719,3.719 false 4.854,3.052 5.292,3.052 false 4.333,4.219 4.771,4.219 false 2.313,2.688 2.75,2.688 false 1.469,2.219 1.906,2.219 false 2.188,3.219 2.625,3.219 false 2.365,3.938 2.802,3.938 false 0.854,2.792 1.104,2.792 false 0.667,3.302 1.115,3.302 false 6.208,2.219 6.208,1.75 6.208,1.75 6.385,1.75 false 1.365,3.875 1.656,4.073 0.292,0.198 10 false x 2 3.188,3.479 3.479,3.677 0.292,0.198 10 false x 9 2.208,4.323 2.5,4.521 0.292,0.198 10 false x 2 6.719,1.594 7.063,1.917 0.344,0.323 18 false 2 4.146,0.083 4.49,0.406 0.344,0.323 18 false 3 2.229,0.531 2.573,0.854 0.344,0.323 18 false 4 2.313,1.125 2.656,1.448 0.344,0.323 18 false 5 6.771,3.552 7.115,3.875 0.344,0.323 18 false 6 2.667,3.052 3.01,3.375 0.344,0.323 18 false 7 0.677,2.625 1.021,2.948 0.344,0.323 18 false 8 2.813,3.76 3.156,4.083 0.344,0.323 18 false 10 0.344,3.125 0.688,3.448 0.344,0.323 18 false 11 1.938,2.042 2.281,2.365 0.344,0.323 18 false 9 2.802,2.51 3.146,2.833 0.344,0.323 18 false 9 4.823,4.021 5.167,4.344 0.344,0.323 18 false 12 5.302,2.854 5.646,3.177 0.344,0.323 18 false 13 3.573,2.521 3.917,2.844 0.344,0.323 18 false 14 1.656,3.531 1.948,3.729 0.292,0.198 10 false x 2

Procedure Part Name Code
Z101186

Z101188

Z101187

2 REAR NO. 1 SEAT RECLINING COVER LH 71834S (Click here) - -
3 REAR SEAT ADJUSTER BOLT COVER 72329F - - -
4 RECLINING ADJUSTER RELEASE HANDLE RH 72525R - - -
5 REAR NO. 1 SEAT RECLINING COVER RH 71833S (Click here) - -
6 NO. 1 FOLD SEAT STOPPER BAND ASSEMBLY 78950F - - -
7 NO. 1 SEAT NO. 2 CUSHION COVER 79952A - - -
8 NO. 1 SEAT NO. 1 CUSHION COVER 79951B - - -
9 REAR NO. 1 SEAT NO. 4 LEG SIDE COVER 79967W - - -
10 REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH 71302C - - -
11 REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH 71301G - - -
12 REAR SEAT CUSHION COVER RH 72995F - - -
13 REAR SEAT CUSHION UNDER COVER RH 72927F - - -
14 SEAT HEATER CONTROL SUB-ASSEMBLY RH 87501E - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the seat heater control sub-assembly RH removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

CAUTION:
B543257

·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Move both front seats to the frontmost position and fold them forward.



PROCEDURE

Hide 71834S 2.REMOVE REAR NO. 1 SEAT RECLINING COVER LH

Z101186

Click here(Click here)

Hide 72525R 4.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

Hide 71833S 5.REMOVE REAR NO. 1 SEAT RECLINING COVER RH

Z101186

Click here(Click here)

Hide 78950F 6.REMOVE NO. 1 FOLD SEAT STOPPER BAND ASSEMBLY

Hide 79967W 9.REMOVE REAR NO. 1 SEAT NO. 4 LEG SIDE COVER

Hide 71302C 10.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY LH

Hide 71301G 11.REMOVE REAR NO. 1 SEAT HINGE SUB-ASSEMBLY RH

Hide 87501E 14.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY RH

a.
B611984