| *A | for RH Seat | - | - |
| ● | Non-reusable part | - | - |
| *1 | NO. 2 SEATBACK FRAME SUB-ASSEMBLY LH | - | - |
| ● | Non-reusable part | - | - |
| *A | w/ Plate | - | - |
| *1 | NO. 2 SEAT CUSHION PAD LH | - | - |
| ● | Non-reusable part | - | - |
| *A | w/ Rear No. 2 Seat Wire LH | - | - |
| *1 | REAR NO. 2 SEAT LEG ASSEMBLY LH | - | - |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
74865H 1.REMOVE CENTER PROTECTOR COVER (for RH Seat)
71694J 2.REMOVE REAR NO. 2 SEAT LOWER CUSHION HINGE COVER LH
|
Remove in this Direction | - | - |
73590 3.REMOVE REAR NO. 2 SEAT INNER BELT ASSEMBLY LH
71692M 4.REMOVE REAR NO. 2 SEAT UPPER CUSHION HINGE COVER LH
|
Remove in this Direction | - | - |
5.REMOVE NO. 2 SEATBACK ASSEMBLY LH
|
Remove in this Direction | - | - |
Using a T45 "TORX" socket wrench, remove the 4 "TORX" bolts and No. 2 seatback assembly LH.
66310P 6.REMOVE ROPE HOOK ASSEMBLY
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Protective Tape | - | - |
Using a thin-bladed screwdriver, lift up the rope hook as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
Using a thin-bladed screwdriver, lift up the rope hook case as shown in the illustration.
Remove the bolt and rope hook assembly.
72615P 7.REMOVE REAR SEATBACK LOCK STRIKER COVER
|
Protective Tape | - | - |
72057K 8.REMOVE REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH
| *a | Cable End | - | - |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Remove the 2 screws and rear seat lock control lever sub-assembly LH.
Detach the clamp.
Twist the cable end as shown in the illustration and remove the cable.
79207C 9.REMOVE NO. 2 SEATBACK BOARD SUB-ASSEMBLY LH
|
Remove in this Direction | - | - |
72635D 10.REMOVE SEATBACK LOCK HOOK
79285C 11.REMOVE NO. 2 SEATBACK PAD LH
|
Remove in this Direction | - | - |
79024D 12.REMOVE NO. 2 SEATBACK COVER SUB-ASSEMBLY LH
|
|
Using a thin-bladed screwdriver, detach the claw to remove the No. 2 seatback cover sub-assembly LH from the No. 2 seatback pad LH as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
72985A 13.REMOVE REAR HEADREST COVER LH
|
Remove in this Direction | - | - |
71697M 14.REMOVE REAR SEAT BACK PROTECTOR
71833N 15.REMOVE REAR NO. 2 SEAT NO. 1 RECLINING COVER LH
|
Remove in this Direction | - | - |
71843Q 16.REMOVE REAR NO. 2 SEAT NO. 2 RECLINING COVER LH
|
Remove in this Direction | - | - |
71834N 17.REMOVE REAR NO. 2 SEAT NO. 3 RECLINING COVER LH
|
Remove in this Direction | - | - |
71844P 18.REMOVE REAR NO. 2 SEAT NO. 4 RECLINING COVER LH
|
Remove in this Direction | - | - |
71987H 19.REMOVE REAR SEAT HEADREST CABLE
| *a | Cable End | - | - |
|
Remove in this Direction | - | - |
Remove the screw and detach the clamp.
Twist the cable end as shown in the illustration and remove the rear seat headrest cable.
71940J 20.REMOVE NO. 2 SEAT HEADREST ASSEMBLY LH
72690K 21.REMOVE REAR SEAT LOCK RELEASE STRAP ASSEMBLY
| *a | Cable End | - | - |
|
Remove in this Direction | - | - |
Detach the clamp.
Twist the cable end as shown in the illustration and remove the rear seat lock release strap assembly.
78910D 22.REMOVE FOLD SEAT LOCK CONTROL CABLE ASSEMBLY LH
| *a | Cable End | - | - |
|
Remove in this Direction | - | - |
Detach the clamp.
Twist the cable end as shown in the illustration and remove the fold seat lock control cable assembly LH.
72622D 23.REMOVE REAR NO. 2 SEAT LEG BUSH
|
Remove in this Direction | - | - |
71849M 24.REMOVE NO. 2 SEAT ADJUSTER COVER CAP LH
|
Remove in this Direction | - | - |
71779E 25.REMOVE LH SEAT REAR SEAT PLATE (w/ Plate)
|
Remove in this Direction | - | - |
79246H 26.REMOVE NO. 2 SEAT LEG COVER LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
79225D 27.REMOVE REAR NO. 2 SEAT CUSHION CARPET
72998D 28.REMOVE REAR SEAT CUSHION COVER LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
72928F 29.REMOVE REAR NO. 2 SEAT CUSHION UNDER COVER LH
|
Remove in this Direction | - | - |
79347A 30.REMOVE NO. 2 SEAT CUSHION UNDER CARPET LH
31.REMOVE SEAT CUSHION COVER WITH PAD
| *a | Fastener | - | - |
|
Remove in this Direction | - | - |
79022B 32.REMOVE NO. 2 SEAT CUSHION COVER SUB-ASSEMBLY LH
|
|
Using a thin-bladed screwdriver, detach the claw to remove the No. 2 seat cushion cover sub-assembly LH from the No. 2 seat cushion pad LH as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
71694J 33.REMOVE REAR NO. 2 SEAT LOWER CUSHION HINGE COVER LH
71693Q 34.REMOVE REAR NO. 2 SEAT LOWER CUSHION HINGE COVER RH
79202B 35.REMOVE NO. 2 SEAT CUSHION FRAME SUB-ASSEMBLY LH
|
Remove in this Direction | - | - |
Using a T40 "TORX" socket wrench, remove the 4 "TORX" bolts and No. 2 seat cushion frame sub-assembly LH.
82196 36.REMOVE REAR NO. 2 SEAT WIRE LH (w/ Rear No. 2 Seat Wire LH)