| *1 | SLIDING ROOF PIECE SUB-ASSEMBLY | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
|
MP grease |
1.INSTALL ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY
| *1 | Spring | *2 | Guide |
|
Install in this Direction (1) |
|
Install in this Direction (2) |
|
Install in this Direction (3) | - | - |
Attach the guide as shown in the illustration to install the roof wind deflector panel sub-assembly in the direction indicated by the arrow (1) shown in the illustration.
Hold down the roof wind deflector panel sub-assembly in the direction indicated by the arrow (2) shown in the illustration.
Attach the 2 springs to the 2 guides of the roof wind deflector panel sub-assembly in the direction indicated by the arrow (3) shown in the illustration.
63223A 2.INSTALL SLIDING ROOF DRIVE CABLE RH
|
|
| *a | Alignment Mark | - | - |
|
Push Position |
|
Install in this Direction |
|
Hold Down | - | - |
Hold down the roof wind deflector panel sub-assembly.
Using a screwdriver, install the sliding roof drive cable RH as shown in the illustration.
Tape the screwdriver tip before use.
Adjust Fully Closed Position:
1. Using a screwdriver with its tip wrapped with protective tape, align the alignment marks as shown in the illustration.
63224A 3.INSTALL SLIDING ROOF DRIVE CABLE LH
|
|
| *a | Alignment Mark | - | - |
|
Push Position |
|
Install in this Direction |
|
Hold Down | - | - |
Hold down the roof wind deflector panel sub-assembly.
Using a screwdriver, install the sliding roof drive cable LH as shown in the illustration.
Tape the screwdriver tip before use.
Adjust Fully Closed Position:
1. Using a screwdriver with its tip wrapped with protective tape, align the alignment marks as shown in the illustration.
4.INSTALL REAR ROOF DRIP CHANNEL
|
|
63306 5.INSTALL SUNSHADE TRIM SUB-ASSEMBLY
63229A 6.INSTALL SLIDING ROOF SUNSHADE STOPPER
63260H 7.INSTALL SLIDING ROOF DRIVE GEAR ASSEMBLY
|
MP grease | - | - |
Install the sliding roof drive gear assembly with the 2 bolts.
|
|
8.INSTALL ROOM LIGHT BRACKET