The main body ECU (multiplex network body ECU) receives switch signals from the multiplex network master switch assembly via LIN communication system. The main body ECU (multiplex network body ECU) activates the door lock motor on each door according to these signals.
The power door lock control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power door lock control system after confirming that the communication systems are functioning properly.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.
The battery supplies power to the main body ECU (multiplex network body ECU) via the door control battery. Therefore, before performing this troubleshooting procedure, make sure to perform an on-vehicle inspection to confirm that the main body ECU (multiplex network body ECU) power source circuit is normal.*
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION
*: w/ Door Control Battery
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Door Lock Switch Status | Multiplex network master switch assembly lock signal | OFF or ON | OFF: Lock side of multiplex network master switch assembly not pushed ON: Lock side of multiplex network master switch assembly pushed |
- |
| Door Unlock Switch Status | Multiplex network master switch assembly unlock signal | OFF or ON | OFF: Unlock side of multiplex network master switch assembly not pushed ON: Unlock side of multiplex network master switch assembly pushed |
- |
| Tester Display |
|---|
| Door Lock Switch Status |
| Door Unlock Switch Status |
On the GTS screen, ON or OFF is displayed for each item according to the table above.
| Proceed to |
|---|
| OK |
| NG |
OK
for LHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL
NG