|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | * | For use with union nut wrench |
Use the same procedure for the RH and LH side.
The following procedure is for the LH side.
48730 1.TEMPORARILY TIGHTEN LOWER CONTROL ARM ASSEMBLY LH
48720 2.TEMPORARILY TIGHTEN LOWER CONTROL ARM ASSEMBLY RH
48540 3.INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
48530 4.INSTALL REAR SHOCK ABSORBER ASSEMBLY RH
48730 5.FULLY TIGHTEN LOWER CONTROL ARM ASSEMBLY LH
48720 6.FULLY TIGHTEN LOWER CONTROL ARM ASSEMBLY RH
| *a | Torque Wrench Fulcrum Length | *b | Union Nut Wrench |
Fully tighten the bolt (A).
Using a union nut wrench, fully tighten the lower control arm assembly RH with the bolt (B).
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 30 mm (1.181 in.)) + torque wrench (fulcrum length of 400 mm (15.748 in.)): 130.2 N*m (1328 kgf*cm, 96 ft.*lbf)