33504F 1.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Disengage the claw to disconnect the shifting hole cover sub-assembly as shown in the illustration.
Using a screwdriver with its tip wrapped with protective tape, expand the left side of the clip and remove the shift lever knob sub-assembly from the floor shift lever assembly as shown in the illustration.
Be careful not to damage the shift lever knob sub-assembly.
The clip is difficult to remove. Check that the clip is installed to the shift lever knob sub-assembly after removing the shift lever knob sub-assembly.
If the installation procedures described in the repair manual are not performed correctly, the shift lever knob sub-assembly may fall off.