The illuminated entry system controls the engine switch illumination.
Check that the "Start Indicator Function" customization setting is set to "ON".
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>CUSTOMIZE PARAMETERS
Before replacing the certification ECU (smart key ECU assembly) or engine switch, refer to Service Bulletin.
When replacing the engine switch, always replace it with a new one.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Start SW Light Power Supply | Engine switch illumination | OFF or ON | - |
| Tester Display |
|---|
| Start SW Light Power Supply |
Engine switch illumination comes on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for 1GR-FE: Click hereEngine / Hybrid System>1GR-FE (STARTING)>ENGINE SWITCH>INSPECTION
for V35A-FTS: Click hereEngine / Hybrid System>V35A-FTS (STARTING)>ENGINE SWITCH>INSPECTION
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1GR-FE) | B |
| NG (for V35A-FTS) | C |
A
B
C
Disconnect the I75 engine switch connector.
Disconnect the I39 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I75,I39)Location & Routingewd_type=routing;type=c,c;code=I75,I39 |
||
| I75-5 (SWIL) - I39-20 (SWIL) | Always | Below 1 Ω |
| I75-3 (GND) - I39-30 (AGND) | Always | Below 1 Ω |
| I75-5 (SWIL) or I39-20 (SWIL) - Body ground | Always | 10 kΩ or higher |
| I75-3 (GND) or I39-30 (AGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG