| *A | w/ Fingerprint Authentication | *B | w/o Fingerprint Authentication |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 10 | ENGINE SWITCH | - | ( ) |
- | - |
| *A | w/ Fingerprint Authentication | *B | w/o Fingerprint Authentication |
| *1 | NO. 1 SWITCH HOLE BASE | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine switch removal/installation are shown below.
1.RESET FINGERPRINT AUTHENTICATION (w/ Fingerprint Authentication)
67914B 2.REMOVE FRONT DOOR SCUFF PLATE LH
62112 3.REMOVE COWL SIDE TRIM BOARD LH
55404D 8.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
55446A 9.REMOVE NO. 1 SWITCH HOLE BASE
| *A | w/ Fingerprint Authentication | *B | w/o Fingerprint Authentication |
89611 10.REMOVE ENGINE SWITCH
|
|
| *A | w/ Fingerprint Authentication | *B | w/o Fingerprint Authentication |
|
Remove in this Direction | - | - |