AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK
Make sure that the customize settings are set to default when performing the automatic light control system operation check.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Headlight ECU)>CUSTOMIZE PARAMETERS
Turn the ignition switch to ON.
Turn the light control switch to the AUTO position.
Cover the automatic light control sensor.
Check that the taillights and low beam headlights come on.
Uncover the automatic light control sensor.
Check that the low beam headlights and taillights turn off.
LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK (except Driver Door-linked Auto Light Turn-off System)
When the light control switch is in the AUTO position
Turn the ignition switch to ON.
Turn the taillights, low beam headlights, high beam headlights and rear fog lights* on.
*: w/ Rear Fog Light
Turn the ignition switch off.
If the vehicle speed was not less than 10 km/h (6 mph) when the ignition switch was turned off, open the driver door.
Check that all of the lights turn off immediately.
When the light control switch is in the tail or head position
Turn the ignition switch to ON.
Turn the low beam headlights and high beam headlights on.
Turn the ignition switch off.
If the vehicle speed was not less than 10 km/h (6 mph) when the ignition switch was turned off, open the driver door.
Check that the low beam headlights and high beam headlights turn off immediately.
The taillights, clearance lights and license plate lights remain on.
LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK (for Driver Door-linked Auto Light Turn-off System)
Close all of the doors.
Turn the ignition switch to ON.
Turn the taillights, low beam headlights, high beam headlights, front fog lights and rear fog lights on.
Turn the ignition switch off.
Open the driver door.
Check that all of the lights turn off immediately.
LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK (w/ Delay Function)
Vehicles displaying the Item "Light Auto OFF Delay" on the GTS:
This check is possible only when the "Light Auto OFF Delay" customize setting is set to "ON" on the GTS.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Headlight ECU)>CUSTOMIZE PARAMETERS
When the taillights are on (low beam headlights are not on)
Close all of the doors.
Turn the ignition switch to ON.
Turn the taillights on.
Turn the ignition switch off.
Open the driver door.
Check that all of the lights turn off immediately.
When the low beam headlights are on
Close all of the doors.
Turn the ignition switch to ON.
Turn the low beam headlights on.
Turn the ignition switch off.
Open any of the doors.
Close the door.
Check that all of the lights turn off after 30 seconds (delay function).
Before the lights turn off, if the lock button on the key is pushed after all of the doors are locked, all of the lights will turn off immediately.
DAYTIME RUNNING LIGHT SYSTEM OPERATION CHECK
Start the engine.
Turn the light control switch to the tail or AUTO position (with the low beam headlights not turned on via the automatic light control system).
Release the parking brake.
Check that the daytime running lights come on.
WELCOME LIGHT ILLUMINATION CONTROL OPERATION CHECK (w/ Welcome Light)
Make sure that the customize settings are set to default when performing the welcome light illumination control operation check.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Headlight ECU)>CUSTOMIZE PARAMETERS
Turn the ignition switch off.
Turn the light control switch to the AUTO position.
Cover the automatic light control sensor.
Close and lock all of the doors.
Unlock all of the doors using the wireless door unlock or entry door unlock function.
Check that the taillights, clearance lights and license plate lights illuminate for 15 seconds.
EXTENDED HEADLIGHT LIGHTING SYSTEM OPERATION CHECK (w/ Extended Headlight Lighting)
Make sure that the customize settings are set to default when performing the extended headlight lighting system operation check.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Headlight ECU)>CUSTOMIZE PARAMETERS
Turn the ignition switch off.
Turn the light control switch to the AUTO position.
Pull the dimmer switch to flash the headlights once.
Check that the low beam headlights come on for approximately 30 seconds.
DOOR MIRROR FOOT LIGHT CONTROL OPERATION CHECK (w/ Door Mirror Footwell Light)
The operation and condition of this control are described below.
| Operation | Condition |
|---|---|
| Fade in and illuminate constantly | When any of the following conditions is met, the lights fade in and illuminate constantly:
·
A key is detected in the actuation area.
·
Any door is unlocked when the ignition switch is off and all of the doors are closed. |
| Illuminate for 15 seconds, and then fade out | When any of the following conditions is met, the lights illuminate for 15 seconds, and then fade out:
·
An actuation area-linked function is used.*
·
Any door is unlocked when the ignition switch is off and all of the doors are closed. |
| Fade out immediately | When the following condition is met, the lights fade out immediately:
·
The ignition switch is turned from off to ON.
·
A key is not detected in the actuation area.
·
All doors are locked when all doors are closed and any door is unlocked. |
*: When the lights are on, the lights fade out approximately 3 seconds after the key leaves the actuation areas around the doors.
STEP LIGHT CONTROL OPERATION CHECK (w/ Step Light)
The operation and condition of are described below.
| Operation | Condition |
|---|---|
| Fade in and illuminate constantly | When any of the following conditions is met, the lights fade in and illuminate constantly:
·
A key is detected in the actuation area.
·
Any door is unlocked when the ignition switch is off and all of the doors are closed. |
| Illuminate for 15 seconds, and then fade out | When any of the following conditions is met, the lights illuminate for 15 seconds, and then fade out:
·
An actuation area-linked function is used.*
·
Any door is unlocked when the ignition switch is off and all of the doors are closed. |
| Fade out immediately | When the following condition is met, the lights fade out immediately:
·
The ignition switch is turned from off to ON.
·
A key is not detected in the actuation area.
·
All doors are locked when all doors are closed and any door is unlocked. |
*: When the lights are on, the lights fade out approximately 3 seconds after the key leaves the actuation areas around the doors.
CORNERING LIGHT CONTROL OPERATION CHECK (w/ Cornering Light)
Turn the ignition switch to ON.
Turn the light control switch to the HEAD position.
Perform the following operations while driving the vehicle at 30 km/h (19 mph) or less and check that the cornering lights operate appropriately.
Operate the right turn signal switch and check that the cornering light RH illuminates.
Operate the left turn signal switch and check that the cornering light LH illuminates.
Turn the steering wheel 80 degrees or more to the right and check that the cornering light RH illuminates. Turn the steering wheel to an angle of 30 degrees or less and check that the cornering light RH turns off.
Turn the steering wheel 80 degrees or more to the left and check that the cornering light LH illuminates. Turn the steering wheel to an angle of 30 degrees or less and check that the cornering light LH turns off.
Move the shift lever to R and check that the cornering light LH and cornering light RH illuminate.
AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM OPERATION CHECK
Stop the vehicle on a level surface and keep the vehicle height unchanged.
Start the engine.
Check that the headlight leveling motors operate.