The headlight ECU sub-assembly stores this DTC if it detects an internal malfunction related to the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U100049 | CAN Register Fixing Internal Electronic Failure |
Detection condition:
The ignition switch is ON.
Malfunction status:
CAN communication failure
Malfunction duration:
- |
Headlight ECU sub-assembly LH | Headlight Control | A |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U100049 | CAN Register Fixing Internal Electronic Failure |
Detection condition:
The ignition switch is ON.
Malfunction status:
CAN communication failure
Malfunction duration:
- |
Headlight ECU sub-assembly RH | Headlight Control (Sub) | A |
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Headlight ECU)>REGISTRATION
When replacing the headlight ECU sub-assembly LH, always replace it with a new one. If a headlight ECU sub-assembly LH which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| U100049 is not output | A |
| U100049 is output | B |
A
B
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| U100049 is not output | A |
| U100049 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B