Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ECU › 2021.04–2022.11
RM38G0E _59 Vehicle Exterior _100649 LIGHTING (EXT) _0468041 HEADLIGHT ECU A

LIGHTING (EXT)  HEADLIGHT ECU  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E465365N01
3,2.01 4.813,3.667 1.813,1.656 4.031,2.365 4.365,2.365 false 4.531,1.208 4.969,1.208 false 4.813,2.802 5.292,2.802 false 3.302,2.99 3.635,2.99 false 5.031,1.073 5.313,1.427 0.281,0.354 18 false 1 4.281,3.417 4.74,3.615 0.458,0.198 10 false x 3 5.396,2.677 5.677,3.031 0.281,0.354 18 false 2 4.563,2.219 4.844,2.573 0.281,0.354 18 false 3 3.146,2.896 3.458,3.094 0.313,0.198 10 false *1 4.427,2.25 4.583,2.448 0.156,0.198 10 false ●

Procedure Part Name Code
Z101186

Z101188

Z101187

1 HEADLIGHT ASSEMBLY LH - - - -
2 HEADLIGHT ECU SUB-ASSEMBLY LH 81056A - - -
3 HEADLIGHT GASKET 81134 - - -

*1 HEADLIGHT ECU LH - -
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly LH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function when Necessary Procedures are not Performed Link
Front bumper assembly (Including removal and installation)
w/ Parking Support Brake System:
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (Click here)
Front television camera view adjustment Panoramic view monitor system (Click here)
Front television camera assembly, front bumper assembly or radiator grille
·

Television camera view adjustment

HINT:

Replacement or removal and installation of 2 or more parts


·

Rear television camera view adjustment (for Rear camera detection system)


Panoramic view monitor system (Click here)
Headlight ECU sub-assembly LH
w/ Adaptive Variable Suspension System:

Synchronize the vehicle information


Automatic headlight beam level control system (Click here)
w/o Adaptive Variable Suspension System:
·

Synchronize the vehicle information

·

Perform headlight ECU sub-assembly LH initialization



CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1.REMOVE HEADLIGHT ASSEMBLY LH

Hide 81056A 2.REMOVE HEADLIGHT ECU SUB-ASSEMBLY LH

a.
E465367C01
0,0 0,0 false
V100135

Screw
V100136

Connector



Hide 81134 3.REMOVE HEADLIGHT GASKET

a.
E465369