| *1 | DISC BRAKE CYLINDER ASSEMBLY | *2 | SET RING |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE CYLINDER BOOT
Using a screwdriver with its tip wrapped with protective tape, remove the 4 set rings from the disc brake cylinder assembly.
Using a screwdriver with its tip wrapped with protective tape, remove the 4 cylinder boots from the disc brake cylinder assembly.
Be careful not to damage the brake piston and disc brake cylinder assembly.
47731 2.REMOVE FRONT DISC BRAKE PISTON
| *a | Wooden Block | - | - |
Install a wooden block between the pistons of the disc brake cylinder assembly to stop them coming out.
Using an air gun, gradually apply compressed air until the 4 front disc brake pistons touch the wooden block.
|
|
Do not allow any brake fluid to spatter.
Remove the Wooden block.
Remove the 4 front disc brake pistons from the disc brake cylinder assembly.
Be careful not to damage the disc brake cylinder assembly and front disk brake pistons.
3.REMOVE PISTON SEAL
Using a screwdriver with its tip wrapped with protective tape, remove the 4 piston seals from the disc brake cylinder assembly.
Do not damage the inner surface or piston seal groove of the disc brake cylinder assembly.
31478B 4.REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
47547B 5.REMOVE FRONT DISC BRAKE BLEEDER PLUG