Home › Brake › PARKING BRAKE › FORCED RELEASE
RM38G0E _54 Brake _100998 PARKING BRAKE _0468754 FORCED RELEASE A

PARKING BRAKE  FORCED RELEASE  OPERATION METHOD  


CAUTION / NOTICE / HINT

CAUTION:
C458799

·

If work is performed without first securing the vehicle, the vehicle may start moving and cause a serious accident or other disaster. Therefore, be sure to apply the use wheel chocks to secure the vehicle before performing work.

·

Work on a level surface to ensure safety.



PROCEDURE

Hide 62538C 2.REMOVE QUARTER TRIM HOLE COVER

a.
C457484

Remove the quarter trim hole cover.


Hide 3. PARKING BRAKE FORCED RELEASE

CAUTION:

Work on a level surface to ensure safety.


NOTICE:
·

When moving the vehicle after releasing the parking brake, install all parts and do not connect the 2 connectors shown in the illustration.

C457485

·

If the ignition switch is on (IG) or the engine is started with the 2 connectors disconnected, a DTC may be stored. Clear any DTCs after performing work.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



a.

Park the vehicle on a level surface and check that the shift lever is in P.


b.

Turn the ignition switch off and use wheel chocks to secure the vehicle.


c.

Check that the 2 connectors shown in the illustration have been disconnected.

C457485


d.

Remove the rear wheel.

Click hereGeneral>MAINTENANCE>TIRE AND WHEEL>REMOVAL

CAUTION:

When using a jack to lift the vehicle, make sure to support the vehicle using safety stands. Do not work on the vehicle with it supported only by a jack.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>VEHICLE LIFT AND SUPPORT LOCATIONS



e.

w/ PARKING BRAKE ACTUATOR PROTECTOR ASSEMBLY:

Remove the parking brake actuator protector assembly from the rear disc brake cylinder assembly.

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>REMOVAL


f.

Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>REMOVAL


g.

Remove the parking brake actuator assembly from the rear disc brake cylinder assembly.

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>REMOVAL


h.

Insert a T50 "TORX" socket wrench into the rear disc brake cylinder assembly.


i.
C457488

Turn the T50 "TORX" socket wrench 2 full rotations clockwise to release the parking brake lock.

NOTICE:

When moving the vehicle after releasing the parking brake, install all parts and do not connect the 2 connectors shown in the illustration.

C457485



Hide 62538C 4.INSTALL QUARTER TRIM HOLE COVER