| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( ) |
- | - |
| 2 | RELEASE PARKING BRAKE | - | - | - | ( ) |
| 3 | REAR WHEEL | - | - | - | - |
| *A | w/ PARKING BRAKE ACTUATOR PROTECTOR ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
2.RELEASE PARKING BRAKE
Perform the following procedure.
1. Move the shift lever to P.
2. Turn the ignition switch ON.
3. Operate the electric parking brake switch assembly to release the parking brake.
If the parking brake cannot be released:
Click hereBrake>PARKING BRAKE>FORCED RELEASE>OPERATION METHOD
4. Turn the ignition switch off.
3.REMOVE REAR WHEEL
46170 4.REMOVE PARKING BRAKE ACTUATOR PROTECTOR ASSEMBLY (w/ PARKING BRAKE ACTUATOR PROTECTOR ASSEMBLY)
890C0A 5.DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
|
|
46310B 6.REMOVE PARKING BRAKE ACTUATOR ASSEMBLY
Using a 5 mm long hexagon socket wrench, remove the 2 bolts and parking brake actuator assembly from the rear disc brake cylinder assembly.
Check for brake fluid leaks on the back side of the rear disc brake cylinder assembly.
If there are any brake fluid leaks, replace the rear disc brake cylinder assembly.
46310C 7.REMOVE PARKING BRAKE ACTUATOR SEAL