This DTC is stored when an UART communication error occurs between the stereo component equalizer assembly and stereo component amplifier assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1AA187 | UART Communication Between ANC and Audio Amplifier Missing Message | When the stereo component equalizer assembly detects a UART communication malfunction in the stereo component amplifier assembly for 4 seconds or more continuously 3 seconds after the ignition switch is turned to ACC* |
·
Harness or connector
·
Stereo component amplifier assembly
·
Stereo component equalizer assembly |
Active Noise Control | A |
*: Malfunction monitoring is not performed during the following conditions to prevent erroneous detection.
The battery voltage is less than 9.5 V.
Before 3 seconds have elapsed after the battery voltage has returned to normal.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| B1AA187 is not output. | A |
| B1AA187 is output. | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Disconnect the S20 stereo component equalizer assembly connector.
Disconnect the S21 stereo component amplifier assembly connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(S20,S21)Location & Routingewd_type=routing;type=c,c;code=S20,S21 Click Connector(S20)Body>No. 2 Floor Wire / Step Rear Floor Wire LH>Stereo Component Equalizer Assemblyewd_type=component;type=c;code=S20;pinno=2,16 Click Connector(S21)Body>No. 2 Floor Wire / Step Rear Floor Wire LH>Stereo Component Amplifier Assemblyewd_type=component;type=c;code=S21;pinno=2,10 |
||
| S20-2 (ACK1) - S21-2 (ACK1) | Always | Below 1 Ω |
| S20-16 (ACK2) - S21-10 (ACK2) | Always | Below 1 Ω |
| S20-2 (ACK1) - Body ground | Always | 10 kΩ or higher |
| S20-16 (ACK2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Replace the stereo component amplifier assembly with a new or known good one.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| B1AA187 is not output. | A |
| B1AA187 is output. | B |
A
B