The radio and display receiver assembly and telephone microphone assembly are connected to each other using the microphone connection detection signal lines.
This DTC is stored when a microphone connection detection signal line is disconnected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1579 | Voice Recognition Microphone Disconnected | Microphone signal is lost |
·
Telephone microphone assembly
·
Radio and display receiver assembly
·
Harness or connector |
Navigation System | A |
When replacing the telephone transceiver assembly, make sure to replace it with a new one. (w/ Telematics Transceiver)
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Pre-procedure1
Disconnect the I13 radio and display receiver assembly connector.
Disconnect the d28*1 or d30*2 telephone microphone assembly connector.
*1: for LHD
*2: for RHD
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I13,d28)Location & Routingewd_type=routing;type=c,c;code=I13,d28 Click Connector(d28)Body>No. 1 Roof Wire>Telephone Microphone Assembly LHewd_type=component;type=c;code=d28;pinno=3,4 |
||
| I13-25 (SNS2) - d28-3 (SNS2) | Always | Below 1 Ω |
| I13-22 (MIN-) - d28-4 (MCO-) | Always | Below 1 Ω |
| I13-25 (SNS2) - Body ground | Always | 10 kΩ or higher |
| I13-22 (MIN-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I13,d30)Location & Routingewd_type=routing;type=c,c;code=I13,d30 Click Connector(d30)Body>No. 1 Roof Wire>Telephone Microphone Assembly RHewd_type=component;type=c;code=d30;pinno=3,4 |
||
| I13-25 (SNS2) - d30-3 (SNS2) | Always | Below 1 Ω |
| I13-22 (MIN-) - d30-4 (MCO-) | Always | Below 1 Ω |
| I13-25 (SNS2) - Body ground | Always | 10 kΩ or higher |
| I13-22 (MIN-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Pre-procedure1
Remove the telephone microphone assembly.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (SNS2) - 4 (MCO-) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
NG