Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio Receiver Type)
RM38G0E _56 Audio / Visual / Telematics _100606 AUDIO / VIDEO _0467495 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  Dimmer Signal Circuit  


DESCRIPTION

The main body ECU (multiplex body ECU) sends an auto dimmer signal to the radio receiver assembly via this circuit.

When the radio receiver assembly receives an auto dimmer signal from the main body ECU (multiplex body ECU), the panel switch of the radio receiver assembly dims and the screen changes to the night screen.

WIRING DIAGRAM

E314785E24
4.958,1.813 6.615,2.146 1.656,0.333 10 false I9 4.958,1.969 6.615,2.302 1.656,0.333 10 false Radio Receiver Assembly 5.24,1.031 6.896,1.365 1.656,0.333 10 false ADIM 5.021,0.938 6.677,1.271 1.656,0.333 10 false 3 1.573,1.042 3.229,1.375 1.656,0.333 10 false ACAN 2.094,0.917 3.75,1.25 1.656,0.333 9 false 29 0.844,1.781 2.5,2.115 1.656,0.333 10 false I3 0.844,1.938 2.5,2.427 1.656,0.49 10 false Main Body ECU (Multiplex Body ECU)

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.


PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY
a.

Disconnect the I9 radio receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition

Click Location & Routing(I9)Location & Routing

Click Connector(I9)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Radio Receiver Assembly

I9-3 (ADIM) - Body ground Ignition switch ON, automatic light control sensor covered by hand, and light control switch in tail or head position 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU])
2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU])
a.

Disconnect the I9 radio receiver assembly connector.


b.

Disconnect the I3 main body ECU (multiplex network body ECU) connector.



Result:
Proceed to
OK
NG



OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR