| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 2 COOLER COMPRESSOR BRACKET | 88849 | - | - | - |
| 2 | MAGNET CLUTCH ASSEMBLY | 88410 | ( ) |
- | - |
| *1 | MAGNET CLUTCH HUB | *2 | MAGNET CLUTCH WASHER |
| *3 | MAGNET CLUTCH ROTOR | *4 | MAGNET CLUTCH STATOR |
| ● | Non-reusable part | - | - |
88849 1.REMOVE NO. 2 COOLER COMPRESSOR BRACKET
| *a | Guide | *b | Clamp |
88410 2.REMOVE MAGNET CLUTCH ASSEMBLY
| *a | SST | - | - |
Remove the magnet clutch assembly using the following procedure.
1. Clamp the compressor with magnet clutch in a vise between aluminum plates.
2. Using SST, hold the magnet clutch hub.
3. Remove the bolt, magnet clutch hub and magnet clutch washer(s).
There is no set number of magnet clutch washers that are used for adjusting clutch clearance.
4. Using SST, remove the snap ring and magnet clutch rotor.
Do not damage the seal cover of the bearing when removing the snap ring.
5. Using SST, remove the snap ring and magnet clutch stator.