Home › Suspension › SUSPENSION CONTROL › ADAPTIVE VARIABLE SUSPENSION SYSTEM
RM38G0E _53 Suspension _100546 SUSPENSION CONTROL _0469072 ADAPTIVE VARIABLE SUSPENSION SYSTEM D

SUSPENSION CONTROL  ADAPTIVE VARIABLE SUSPENSION SYSTEM  TEST MODE PROCEDURE  


TEST MODE PROCEDURE


NOTICE:
·

After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.

·

When vehicle identification information has not been acquired, the "Sport S+" indicator in the combination meter assembly blinks at 1-second intervals (1 second on and 1 second off). After vehicle identification information is acquired, the "Sport S+" indicator in the combination meter assembly blinks at 0.125-second intervals (0.125 seconds on and 0.125 seconds off).



a.

Select "Signal Check".

Chassis > Adaptive Variable Suspension System > Utility
Tester Display
Signal Check
50005 171 3

b.

Confirm that the system is in test mode by checking that the "Sport S+" indicator in the combination meter assembly is blinking at 0.125-second intervals (0.125 seconds on and 0.125 seconds off).


c.

With the vehicle stationary on a level surface, wait for 1 second or more.


d.

Read the test mode DTCs by following the prompts on the GTS screen.


e.

End test mode by following the prompts on the GTS screen.

Chassis > Adaptive Variable Suspension System > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Stop and Start Learning Status Learning status of stop and start setting availability after vehicle identification information registration is performed Unset, OFF or ON OFF: w/o Stop and start system
ON: w/ Stop and start system
When "Unset", DTC C1789 is output.
Chassis > Adaptive Variable Suspension System > Data List
Tester Display
Stop and Start Learning Status
50003 171 108

f.

Check the value displayed on the GTS.

OK:

The display is as specified in the normal condition column.



g.

Turn the ignition switch off and disconnect the GTS from the DLC3.



TEST MODE DTC CHART


If a trouble code is output during the test mode DTC check, check the circuit listed for that code. For details of each code, refer to Link for the respective DTC in the chart.

DTC Code Detection Item Trouble Area Deletion Condition Link
C1796 Front acceleration sensor RH circuit malfunction
·

Front acceleration sensor RH

·

Front acceleration sensor RH circuit

·

Absorber control ECU


With the vehicle stationary on a level surface, an acceleration sensor value that is within -1.96 to 1.96 m/s2 is received from the acceleration sensor for 1 second or more. (Click here)
C1797 Front acceleration sensor LH circuit malfunction
·

Front acceleration sensor LH

·

Front acceleration sensor LH circuit

·

Absorber control ECU


C1798 Rear acceleration sensor circuit malfunction
·

Rear acceleration sensor (Absorber Control ECU)

·

Absorber control ECU