DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
When disconnecting and reconnecting the battery.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
INITIALIZATION
Perform Registration (VIN registration or frame number registration) when replacing the ECM.
Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION
When the ECM is replaced, update the ECU security key.
Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>UPDATE ECU SECURITY KEY
Before replacing the ECM, refer to Service Bulletin (for Immobiliser System).
Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation.
Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.
WHEN USING GTS
Observe the following items for safety reasons:
Before using the GTS, read the instruction manual.
Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes using the GTS, 2 persons are required. One drives the vehicle, and the other operates the GTS.