| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | STEERING LOCK ACTUATOR WITH ECU ASSEMBLY | 45020C | ( ) |
- | - |
| *1 | STEERING LOCK SET BOLT | - | - |
| ● | Non-reusable part | - | - |
Do not drop the steering lock actuator with ECU assembly, strike it with tools or subject it toimpacts.
If the steering lock actuator with ECU assembly is subjected to an impact, replace it with a newone.
45020C 1.REMOVE STEERING LOCK ACTUATOR WITH ECU ASSEMBLY
| *a | Center of the Steering Lock Set Bolt | - | - |
Secure the steering column assembly in a vise between aluminum plates.
Do not overtighten the vise.
Do not clamp the steering lock actuator with ECU assembly in the vise.
Using SST, strike a punch mark for drilling in the center of the steering lock set bolt.
When striking the punch mark, in order to prevent impact force from being applied to the steering lock actuator with ECU assembly, do not use a normal center punch.
Using a drill, drill a hole in 2 steering lock set bolts and insert a screw extractor.
Using the screw extractor, remove the 2 steering lock set bolts and steering lock actuator with ECU assembly.
Push in the screw extractor by hand, and do not strike it with tools, etc.