Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)
RM38G0E _55 Steering _100923 STEERING COLUMN _0469198 STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column) A

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column)  REASSEMBLY  


CAUTION / NOTICE / HINT

COMPONENTS (REASSEMBLY)
C456066N01
4.167,2.177 4.833,2.177 true 2.896,0.229 3.229,0.229 true 5.156,2.063 5.427,2.354 0.271,0.292 18 false 1 2.625,0.146 2.969,0.396 0.344,0.25 10 false ●*1 3.344,0.177 3.698,0.427 0.354,0.25 10 false x 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 STEERING LOCK ACTUATOR WITH ECU ASSEMBLY 45020C (Click here) - -

*1 STEERING LOCK SET BOLT - -
● Non-reusable part - -

CAUTION / NOTICE / HINT

NOTICE:
·

Do not drop the steering lock actuator with ECU assembly, strike it with tools or subject it to impacts.

·

If the steering lock actuator with ECU assembly is subjected to an impact, replace it with a newone.



PROCEDURE

Hide 45020C 1.INSTALL STEERING LOCK ACTUATOR WITH ECU ASSEMBLY

Z101186

NOTICE:

If the steering lock actuator with ECU assembly is replaced, refer to Service Bulletin.



a.
C456070N01
0.333,0 0.583,0.354 0.25,0.354 18 false i 3.917,0 4.167,0.354 0.25,0.354 18 false ii

i.

Secure the steering column assembly in a vise between aluminum plates.

NOTICE:
·

Do not overtighten the vise.

·

Do not clamp the steering lock actuator with ECU assembly in the vise.




ii.

Install the steering lock actuator with ECU assembly with 2 new steering lock set bolts, and tighten the bolts until they break off.