The cooler magnet valve assembly is controlled by the air conditioning amplifier assembly (for Cool Box).
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the Q71 air conditioning amplifier assembly (for Cool Box) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(Q71)Location & Routingewd_type=routing;type=c;code=Q71 Click Connector(Q71)Instrument Panel>Floor Wire / No. 1 Cooler Wiring Harness Sub-Assembly>Cooling Box Amplifier (Cooling Box Assembly)ewd_type=component;type=c;code=Q71;pinno=12 |
||
| Q71-12 - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(Q71)Location & Routingewd_type=routing;type=c;code=Q71 Click Connector(Q71)Instrument Panel>Floor Wire / No. 1 Cooler Wiring Harness Sub-Assembly>Cooling Box Amplifier (Cooling Box Assembly)ewd_type=component;type=c;code=Q71;pinno=1,2 |
||
| Q71-1 - Body ground | Always | 11 to 14 V |
| Q71-2 - Body ground | Ignition switch off | Below 1 V |
| Q71-2 - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the Q71 air conditioning amplifier assembly (for Cool Box) connector.
Disconnect the Q35 cooler magnet valve assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(Q71,Q35)Location & Routingewd_type=routing;type=c,c;code=Q71,Q35 Click Connector(Q71)Instrument Panel>Floor Wire / No. 1 Cooler Wiring Harness Sub-Assembly>Cooling Box Amplifier (Cooling Box Assembly)ewd_type=component;type=c;code=Q71;pinno=7,2 Click Connector(Q35)Instrument Panel>Floor Wire / No. 1 Cooler Wiring Harness Sub-Assembly>Cooler Magnet Valve Assemblyewd_type=component;type=c;code=Q35;pinno=1,2 |
||
| Q71-7 - Q35-1 (VC) | Always | Below 1 Ω |
| Q71-2 - Q35-2 (STBI) | Always | Below 1 Ω |
| Q71-7 or Q35-1 (VC) - Other terminals and body ground | Always | 10 kΩ or higher |
| Q71-2 or Q35-2 (STBI) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the cooler magnet valve assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX (w/ Cool Box)>DISASSEMBLY
Since the cooler magnet valve cannot be inspected while it is removed from the vehicle, replace the cooler magnet valve with a normal one and check that the condition returns to normal.
Same problem does not occur.
| Proceed to |
|---|
| OK |
| NG |
OK
NG