CHECK MOBILE WIRELESS CHARGER CRADLE ASSEMBLY
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
|
*1: When the ignition switch is turned from off to ACC, the mobile wireless charger cradle assembly monitors the charging suspension signal for 5 seconds. If the charging suspension signal is not 4 V or more for 0.8 seconds or more during monitoring, the mobile wireless charger cradle assembly determines that there is an open in the charging suspension signal line, blinks (pattern 1) the indicator light (amber), and prohibits operation until the ignition switch is turned from off to ACC again. *2: For details about conditions when the certification ECU (smart key ECU assembly) sends the charging suspension signal, refer to System Description. |
|||
| I142-1 (PGND) - Body ground | Ground | Always | Below 1 V |
| I142-3 (ACC) - I142-1 (PGND) | Power source (ACC) | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| I142-4 (B+) - I142-1 (PGND) | Power source (+B) | Always | 11 to 14 V |
| I142-8 (DIS) - Body ground | Charging suspension signal | For 5 seconds after turning ignition switch from off to ACC*1 | 4.5 to 6.0 V |
| Device being charged | Below 1 V | ||
| Charging suspended due to the smart key system status*2 | 4.5 to 6.0 V | ||
| I142-7 (TAIL) - Body ground | Taillight signal | Ignition switch ON, light control switch off | Below 1 V |
| Ignition switch ON, light control switch TAIL | 11 to 14 V | ||