This is the power source circuit for the mobile wireless charger cradle assembly.
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the I142 mobile wireless charger cradle assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I142)Location & Routingewd_type=routing;type=c;code=I142 |
||
| I142-1 (PGND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I142)Location & Routingewd_type=routing;type=c;code=I142 |
||
| I142-4 (B+) - Body ground | Always | 11 to 14 V |
| I142-3 (ACC) - Body ground | Ignition switch ACC | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG