Home › Vehicle Interior › POWER OUTLETS (INT) › WIRELESS CHARGING SYSTEM
RM38G0E _58 Vehicle Interior _100440 POWER OUTLETS (INT) _0469278 WIRELESS CHARGING SYSTEM J

POWER OUTLETS (INT)  WIRELESS CHARGING SYSTEM  Wireless Charger Illumination Circuit  


DESCRIPTION

When the taillight is on, this circuit sends an illumination signal to the mobile wireless charger cradle assembly.

WIRING DIAGRAM

B605413E04
0.958,0.938 2.344,1.167 1.385,0.229 10 false from PANEL Relay 4.813,0.927 5.229,1.104 0.417,0.177 10 false TAIL 4.615,0.844 4.792,1.031 0.177,0.188 10 false 7 4.771,1.479 6.313,1.885 1.542,0.406 10 false Mobile Wireless Charger Cradle Assembly 4.771,1.313 5.083,1.49 0.313,0.177 10 false I142

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
a.

Disconnect the I142 mobile wireless charger cradle assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(I142)Location & Routing

Click Connector(I142)Instrument Panel>Instrument Panel Wire / Mobile Wireless Charger Cord / No. 1 Navigation Wire / No. 2 Instrument Panel Wire / No. 5 Instrument Panel Wire / Telephone Computer Wire>Mobile Wireless Charger Cradle Assembly

I142-7 (TAIL) - Body ground Ignition switch ON, light control switch off Below 1 V
Ignition switch ON, light control switch TAIL 11 to 14 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR