CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)
Disconnect the d19 sliding roof ECU (sliding roof drive gear assembly) connector.
Measure the resistance and voltage according to the value(s) in the table below.
Measure the values on the wire harness side with the connector disconnected.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| d19-1 (B) - d19-2 (E) | Battery power supply | Always | 11 to 14 V |
| d19-2 (E) - Body ground | Ground | Always | Below 1 Ω |
Reconnect the d19 sliding roof ECU (sliding roof drive gear assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| d19-10 (OPN) - d19-2 (E) | Sliding roof motor open | Ignition switch ON, OPEN switch on | Below 1 V |
| d19-10 (OPN) - d19-2 (E) | Sliding roof motor open | Ignition switch ON, OPEN switch off | 11 to 14 V |
| d19-8 (CLS) - d19-2 (E) | Sliding roof motor close | Ignition switch ON, CLOSE switch on | Below 1 V |
| d19-8 (CLS) - d19-2 (E) | Sliding roof motor close | Ignition switch ON, CLOSE switch off | 11 to 14 V |
| d19-5 (UP) - d19-2 (E) | Sliding roof motor up | Ignition switch ON, UP switch on | Below 1 V |
| d19-5 (UP) - d19-2 (E) | Sliding roof motor up | Ignition switch ON, UP switch off | 11 to 14 V |
| d19-9 (DWN) - d19-2 (E) | Sliding roof motor down | Ignition switch ON, DOWN switch on | Below 1 V |
| d19-9 (DWN) - d19-2 (E) | Sliding roof motor down | Ignition switch ON, DOWN switch off | 11 to 14 V |
CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>TERMINALS OF ECU