Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SYSTEM
RM38G0E _59 Vehicle Exterior _100826 SLIDING ROOF / CONVERTIBLE _0469275 SLIDING ROOF SYSTEM C

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF SYSTEM  B2345  Motor Control Relay Stuck ON  


DESCRIPTION

This DTC will be stored if the operation of the sliding roof is suspended and a pulse input of 10 Hz or more is detected when the motor relay is off.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B2345 Motor Control Relay Stuck ON Position failure (When the sliding roof drive gear assembly (sliding roof ECU) enters fail-safe mode due to a problem with the gear position) Sliding roof drive gear assembly (sliding roof ECU) Sliding Roof A

CAUTION / NOTICE / HINT

NOTICE:
·

If the sliding roof ECU (sliding roof drive gear assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear assembly) must be initialized.

Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>INITIALIZATION

·

DTC B2345 is stored in the sliding roof drive gear assembly (sliding roof ECU).



PROCEDURE

1.CHECK DTC OUTPUT

Pre-procedure1

a.

Clear the DTCs.

Body Electrical > Sliding Roof > Clear DTCs
50002 147

Procedure1

b.

Check for DTCs.

Body Electrical > Sliding Roof > Trouble Codes
50001 147
Result:
Result Proceed to
DTCs are not output A
DTCs are output B



Post-procedure1

c.

None



A

B

REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)