TROUBLESHOOTING PRECAUTIONS
When inspecting the rear brakes, disconnect the connector of the parking brake actuator assembly or disconnect the cable from the negative (-) battery terminal in order to shut off the supply of electrical power.
Do not perform the rear brake inspection while either the No. 2 skid control ECU (brake actuator assembly) connector or the negative (-) battery terminal are connected.
The rear disc brake piston could operate, resulting in an accident such as hands being caught.
When disconnecting a connector or removing a fuse or relay, make sure that the ignition switch has been off, the brake pedal has not been depressed, and the driver door has been closed for 4 minutes or more*.
*: The electric parking brake may still operate up to 60 minutes depending on the state of the vehicle after the ignition switch is turned off, so be sure to perform the work procedures with the vehicle on a level surface.
When any parts have been removed or installed, check for DTCs after completion of installation to confirm that the system is operating correctly.
After performing work procedures such as installation, if the parking brake indicator light is blinking, the parking brake must be released.
HANDLING PRECAUTIONS
When tilting the vehicle to perform work after parking the vehicle on a level surface, the braking force may not be sufficient. Make sure to pull the electric parking brake switch assembly to the lock side 2 times (2 lock operations).
The electric parking brake system determines the amount of force used to operate the parking brake according to the tilt angle detected by the deceleration sensor (airbag sensor with ECU assembly).
When the parking brake indicator is illuminated after the electric parking brake switch assembly has been pulled to the lock side, the maximum amount of braking force is applied if the electric parking brake switch assembly is pulled to the lock side one more time.
The parking brake indicator light blinks when the ignition switch is turned to ON after replacing the No. 2 skid control ECU (brake actuator assembly). Operate the electric parking brake switch assembly to turn off the parking brake indicator light.
When replacing the No. 2 skid control ECU (brake actuator assembly), always check that ECU security key is registered.
Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>UPDATE ECU SECURITY KEY
PRECAUTIONS FOR TOWING VEHICLES
For towing precautions: Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
PARKING BRAKE FORCED RELEASE METHOD
For the parking brake forced release method: Click hereBrake>PARKING BRAKE>FORCED RELEASE>OPERATION METHOD