Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM
RM38G0E _54 Brake _100998 PARKING BRAKE _0469398 ELECTRIC PARKING BRAKE SYSTEM C

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  C059704  Brake System Control Module "A" System Internal Failure  C059746  Brake System Control Module "A" Calibration / Parameter Memory Failure  C13CF1C  Left Electric Parking Brake Actuator Current Sensor Circuit Voltage Out of Range  C13D41C  Right Electric Parking Brake Actuator Current Sensor Circuit Voltage Out of Range  


DESCRIPTION

The following DTCs are stored when a malfunction occurs in the No. 2 skid control ECU (brake actuator assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
C059704 Brake System Control Module "A" System Internal Failure No. 2 skid control ECU (brake actuator assembly) internal malfunction No. 2 skid control ECU (brake actuator assembly) DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
C059746 Brake System Control Module "A" Calibration / Parameter Memory Failure No. 2 skid control ECU (brake actuator assembly) internal malfunction No. 2 skid control ECU (brake actuator assembly) DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
C13CF1C Left Electric Parking Brake Actuator Current Sensor Circuit Voltage Out of Range No. 2 skid control ECU (brake actuator assembly) internal malfunction No. 2 skid control ECU (brake actuator assembly) DTC stored An electric parking brake system malfunction is displayed on the multi-information display.
C13D41C Right Electric Parking Brake Actuator Current Sensor Circuit Voltage Out of Range No. 2 skid control ECU (brake actuator assembly) internal malfunction No. 2 skid control ECU (brake actuator assembly) DTC stored An electric parking brake system malfunction is displayed on the multi-information display.

CAUTION / NOTICE / HINT

NOTICE:
·

To ensure that the electric parking brake does not operate, wait for 4 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.

·

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY

·

When replacing the No. 2 skid control ECU (brake actuator assembly), operate the electric parking brake switch assembly as the parking brake indicator light blinks when the ignition switch is first turned ON.



PROCEDURE

1.REPLACE NO. 2 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)

NEXT

END