Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM
RM38G0E _54 Brake _100998 PARKING BRAKE _0469398 ELECTRIC PARKING BRAKE SYSTEM J

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  Brake Warning Light (Yellow) Remains On  


DESCRIPTION

This procedure is for troubleshooting when the brake warning light (yellow) remains on but no DTCs are output.

The No. 2 skid control ECU (brake actuator assembly) controls the brake warning light (yellow) in the combination meter assembly via CAN communication.

CAUTION / NOTICE / HINT

NOTICE:
·

To ensure that the electric parking brake does not operate, wait for 4 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.

·

After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY

·

When replacing the No. 2 skid control ECU (brake actuator assembly), operate the electric parking brake switch assembly as the parking brake indicator light blinks when the ignition switch is first turned ON.



PROCEDURE

1.CHECK VEHICLE CONTROL HISTORY (ELECTRIC PARKING BRAKE SYSTEM)
a.

Using the GTS, check for Vehicle Control History.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>VEHICLE CONTROL HISTORY (RoB)

Chassis > Brake/EPB > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 1055
HINT:

If vehicle control history is stored when the electric parking brake system is suspended, the brake warning light (yellow) illuminates.



Result:
Result Proceed to
There is no vehicle control history for when the electric parking brake system was suspended. A
There is vehicle control history for when the electric parking brake system was suspended. B



A

2.INSPECT COMBINATION METER ASSEMBLY (BRAKE WARNING LIGHT (YELLOW))

B

PERFORM TROUBLESHOOTING AND REPAIR REGARDING VEHICLE CONTROL HISTORY

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>VEHICLE CONTROL HISTORY (RoB)

NOTICE:

After performing troubleshooting and repair regarding vehicle control history, clear the vehicle control history.



2.INSPECT COMBINATION METER ASSEMBLY (BRAKE WARNING LIGHT (YELLOW))
a.

Perform the Active Test of the combination meter assembly using the GTS.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Combination Meter > Active Test
Tester Display
ECB Warning
50004 409 110

b.

Check the combination meter assembly.

OK:

The brake warning light (yellow) turns on or off in accordance with GTS operation.



Result:
Proceed to
OK
NG



OK

NG