Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM38G0E _54 Brake _100463 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0469467 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C052062  Multi-axis Acceleration Sensor Module "A" Signal Compare Failure  


DESCRIPTION

The yaw rate and acceleration sensor has a built-in airbag sensor with ECU assembly.

The No. 2 skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor with ECU assembly) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Note
C052062 Multi-axis Acceleration Sensor Module "A" Signal Compare Failure After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference remains 0.4 G or more for 60 seconds or more.
·

Acceleration sensor (airbag sensor with ECU assembly) installation

·

Acceleration sensor (airbag sensor with ECU assembly)


Brake/EPB Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor with ECU assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY


PROCEDURE

1.CHECK AIRBAG SENSOR WITH ECU ASSEMBLY INSTALLATION
a.

Check that the yaw rate and acceleration sensor (airbag sensor with ECU assembly) has been installed properly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION

OK:

The yaw rate and acceleration sensor (airbag sensor with ECU assembly) is tightened to the specified torque.

The yaw rate and acceleration sensor (airbag sensor with ECU assembly) is not installed in a tilted position.



Result:
Proceed to
OK
NG



OK

NG

INSTALL AIRBAG SENSOR WITH ECU ASSEMBLY CORRECTLY