Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM38G0E _54 Brake _100463 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0469467 ELECTRONICALLY CONTROLLED BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  C124F62  Yaw Rate Sensor Signal Compare Failure  


DESCRIPTION

The airbag sensor with ECU assembly has a built-in yaw rate and acceleration sensor.

This DTC is stored when the No. 2 skid control ECU (brake actuator assembly) detects improper installation of the yaw rate sensor or an abnormality in the difference between the yaw rate and acceleration sensor (airbag sensor with ECU assembly) value and the control value estimated based on the yaw rate and acceleration sensor (airbag sensor with ECU assembly), steering angle sensor and speed sensor signals.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Note
C124F62 Yaw Rate Sensor Signal Compare Failure A yaw rate sensor comparison malfunction status continues.
·

Yaw rate sensor (airbag sensor with ECU assembly) installation

·

Yaw rate sensor (airbag sensor with ECU assembly)


Brake/EPB Output ECU: No. 2 skid control ECU (brake actuator assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor with ECU assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>UTILITY


PROCEDURE

1.READ VALUE USING GTS (YAW RATE SENSOR)
a.

Perform a road test.


b.

Check the yaw rate sensor output value displayed on the GTS.

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Yaw Rate Sensor Value Yaw rate sensor Min.: -128°/s
Max.: 127°/s
Vehicle stopped: 0°/s
Turning right: -128 to 0°/s
Turning left: 0 to 127°/s
-
Chassis > Brake/EPB > Data List
Tester Display
Yaw Rate Sensor Value
50003 435 29

Result:
Result Proceed to
NG (The yaw rate sensor output value is 0°/s when the vehicle is stationary, but the value fluctuates when turning.) A
NG (The yaw rate sensor output value is not 0°/s when the vehicle is stationary.) B
OK C



A

2.CHECK AIRBAG SENSOR WITH ECU ASSEMBLY INSTALLATION

B

C

2.CHECK AIRBAG SENSOR WITH ECU ASSEMBLY INSTALLATION
a.

Turn the ignition switch off.


b.

Check that the yaw rate sensor (airbag sensor with ECU assembly) has been installed properly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION

OK:

The yaw rate sensor (airbag sensor with ECU assembly) is tightened to the specified torque.

The yaw rate sensor (airbag sensor with ECU assembly) is not installed in a tilted position.



Result:
Proceed to
OK
NG



OK

NG