Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM
RM38G0E _56 Audio / Visual / Telematics _100728 PARK ASSIST / MONITORING _0469673 REAR VIEW MONITOR SYSTEM Y

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the rear view monitor system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
a.

Ask the customer about the problems and the conditions at the time the malfunction occurred to make sure the problem symptom was not temporarily caused by radio waves in the surrounding environment.

HINT:

The rear view monitor display may be temporarily distorted due to radio waves around the vehicle.

Problem Symptom Cause

*: DTCs output as "Hist" will not be output again after DTCs are cleared.

Both of the following conditions are met:
·

The problem symptom indicates a rear view monitor display malfunction and the problem symptom cannot be reproduced.

·

DTC C1622 is output as "Hist" only.*


The display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver.



Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


HINT:

If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.



Result:
Proceed to
NEXT



NEXT

4.CHECK FOR DTC*
4.CHECK FOR DTC*
a.

Check for DTCs and make a note of any codes that are output.

Body Electrical > Navigation System > Trouble Codes
50001 212

b.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Recheck for DTCs. Try to reproduce the problem symptoms based on the recorded DTCs, and then check if the DTCs are output again.

Body Electrical > Navigation System > Trouble Codes
50001 212
NOTICE:

The radio and display receiver assembly may store the DTCs of the following system. If DTCs are output, refer to Diagnostic Trouble Code Chart for the applicable system.

System Proceed to
Audio and Visual System (Click here)



Result:
Result Proceed to
No DTCs are output A
DTCs are output B



A

5.PROBLEM SYMPTOMS CONFIRMATION

B

5.PROBLEM SYMPTOMS CONFIRMATION
Result:
Result Proceed to
Symptom does not occur A
Symptom occurs B



A

6.SYMPTOMS SIMULATION

B

7.CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM
6.SYMPTOMS SIMULATION

NEXT

7.CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM
7.CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM

A

8.PROBLEM SYMPTOMS TABLE

B

8.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



A

9.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW

B

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

9.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW

NEXT

10.ADJUST, REPAIR OR REPLACE
10.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

11.CONFIRMATION TEST
11.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END