| ● | Non-reusable part | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
44250 1.SECURE RACK AND PINION POWER STEERING GEAR ASSEMBLY
| *a | Protective Tape | - | - |
Using SST, secure the rack and pinion power steering gear assembly in a vise.
Remove and install the SST as needed.
45047 2.REMOVE TIE ROD END SUB-ASSEMBLY LH
| *a | Matchmark | - | - |
45046 3.REMOVE TIE ROD END SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
45535B 4.REMOVE STEERING RACK BOOT CLIP (for LH Side)
45535B 5.REMOVE STEERING RACK BOOT CLIP (for RH Side)
Perform the same procedure as for the LH side.
45536A 6.REMOVE NO. 2 STEERING RACK BOOT CLAMP
Using pliers, remove the No. 2 steering rack boot clamp as shown in the illustration.
Be careful not to damage the No. 1 steering rack boot.
45535D 7.REMOVE NO. 1 STEERING RACK BOOT CLAMP
Use the same procedure described for the No. 2 steering rack boot clamp.
45535 8.REMOVE NO. 1 STEERING RACK BOOT (for LH Side)
45535 9.REMOVE NO. 1 STEERING RACK BOOT (for RH Side)
Perform the same procedure as for the LH side.
45503 10.REMOVE STEERING RACK END SUB-ASSEMBLY
| *A | for LH Side | *B | for RH Side |
| *a | Turn | *b | Hold |
Using a SST, hold the steering rack (LH side).
Using SST, remove the steering rack end sub-assembly (LH side) from the power steering rack sub-assembly.
Do not mistake the direction of SST.
Make sure to keep the power steering rack fixed in place with SST.
Rotate SST in the direction shown in the illustration.
Using SST, remove the steering rack end sub-assembly (RH side) from the power steering rack sub-assembly.
Do not mistake the direction of SST.
Make sure to keep the power steering rack fixed in place with SST.
Rotate SST in the direction shown in the illustration.