| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | WASHER NOZZLE SUB-ASSEMBLY | 85035 | ( ) |
- | - |
| *A | w/o Heater | - | - |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 2 | HOOD INSULATOR | 53341B | - | - | - |
| 3 | FRONT WASHER NOZZLE & HOSE ASSEMBLY | 85380 | ( ) |
- | - |
| *A | w/ Heater | - | - |
| ● | Non-reusable part | - | - |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
85035 1.REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/o Heater)
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws as shown in the illustration to separate the washer nozzle sub-assembly.
Be careful not to damage the windshield glass.
Disconnect the washer hose to remove the washer nozzle sub-assembly.
Washer nozzle sub-assemblies cannot be reused.
53341B 2.REMOVE HOOD INSULATOR (w/ Heater)
85380 3.REMOVE FRONT WASHER NOZZLE & HOSE ASSEMBLY (w/ Heater)
|
Washer Hose |
|
Connector |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Protective Tape | - | - |
Disconnect the connector and washer hose.
Using a moulding remover D with its tip wrapped with protective tape, detach the claw as indicated by the arrows, in the order shown in the illustration to remove the front washer nozzle & hose assembly.
Be careful not to damage the windshield glass.
Front washer nozzle & hose assembly cannot be reused.