Home › Engine / Hybrid System › V35A-FTS (ENGINE CONTROL) › SFI SYSTEM
RM38G0E _51 Engine / Hybrid System _100526 V35A-FTS ENGINE CONTROL _0470271 SFI SYSTEM C

V35A-FTS ENGINE CONTROL  SFI SYSTEM  P023A00  Charge Air Cooler Coolant Pump Control Circuit/Open  P023A71  Charge Air Cooler Coolant Pump Control Actuator Stuck  


DESCRIPTION

Refer to DTC P023A12.

Click hereEngine / Hybrid System>V35A-FTS (ENGINE CONTROL)>SFI SYSTEM>P023A12

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note
P023A00 Charge Air Cooler Coolant Pump Control Circuit/Open The speed of the electric water pump assembly is higher than the target speed by a fixed value or more (2 trip detection logic).
·

Lack of intercooler coolant

·

Intercooler coolant leak

·

Electric water pump assembly


- SAE: P023A
P023A71 Charge Air Cooler Coolant Pump Control Actuator Stuck The speed of the electric water pump assembly is lower than the target speed by a fixed value or more (2 trip detection logic). Electric water pump assembly - SAE: P023A

MONITOR DESCRIPTION

The ECM monitors the speed of the electric water pump assembly. If the actual speed exceeds the target speed by a fixed value or more, the ECM evaluates overspeed operation. If the actual speed is below the target speed by a fixed value or more, the ECM evaluates that the motor is stuck. In these cases it stores a DTC.

CAUTION / NOTICE / HINT

HINT:
·

Read Freeze Frame Data using the GTS. The ECM records vehicle and driving condition information as Freeze Frame Data the moment a DTC is stored. When troubleshooting, Freeze Frame Data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

·

P023A00 may be detected if operation continues when the coolant (for intercooler) is insufficient. If there is sufficient coolant (for intercooler) and P023A00 is output when the vehicle is brought to the workshop, check if the customer has added extra coolant to the intercooler in the past.

·

If the electric water pump assembly voltage is high or low, control may be temporarily stopped and P023A71 may be output. When the high- or low-voltage status situation is resolved, the temporarily halted control returns to normal. Therefore, it is not necessary to replace the electric water pump assembly.



PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P023A00 OR P023A71)
a.

Read the DTCs.

Powertrain > Engine > Trouble Codes
50001 372
Result:
Result Proceed to
P023A00 or P023A71 is output A
P023A00 or P023A71 and other DTCs are output B


HINT:

If any DTCs other than P023A00 or P023A71 are output, troubleshoot those DTCs first.




A

2.PERFORM ACTIVE TEST USING GTS (CONTROL THE INTERCOOLER WATER PUMP)

B

GO TO DTC CHART

2.PERFORM ACTIVE TEST USING GTS (CONTROL THE INTERCOOLER WATER PUMP)
NOTICE:

Be sure to perform the inspection with the battery voltage at 11 V or more.


HINT:

If the battery voltage is low, the electric water pump assembly may stop operating.


a.

Read the Data List during 85% drive of the electric water pump.

Powertrain > Engine > Active Test
Active Test Display
Control the Intercooler Water Pump
Data List Display
Intercooler Water Pump Speed
50004 372 9 104
Result:
GTS Operation Electric Water Pump Speed Proceed to
85% 4000 rpm or less A
7000 rpm or more B
Other than above C


HINT:
·

If the electric water pump assembly voltage is high or low, control may be temporarily stopped and a DTC stored.

·

Freezing occurs at -15°C at 30% coolant concentration and at -35°C at 50% coolant concentration.

·

DTC P023A71 is stored if the electric water pump assembly cannot rotate due to freezing.

·

If DTC P023A71 is stored due to freezing of the coolant, the problem cannot be reproduced. Judge whether freezing of the coolant occurred from the coolant replacement history and the ambient temperature when the DTC was stored.





A

3.REPLACE ELECTRIC WATER PUMP ASSEMBLY

B

4.CHECK COOLANT LEVEL AT RESERVOIR

C

3.REPLACE ELECTRIC WATER PUMP ASSEMBLY

NEXT

8.PERFORM ACTIVE TEST USING GTS (CONTROL THE INTERCOOLER WATER PUMP)
4.CHECK COOLANT LEVEL AT RESERVOIR

Click hereEngine / Hybrid System>V35A-FTS (INTAKE / EXHAUST)>COOLANT>ON-VEHICLE INSPECTION

Result:
Result Proceed to
At or below reservoir tank LOW level. A
At or above reservoir tank LOW level. B



A

5.CHECK FOR COOLANT LEAK

B

7.BLEED AIR
5.CHECK FOR COOLANT LEAK
a.

Check the turbocharger and intercooler cooling system for coolant leaks.

Click hereEngine / Hybrid System>V35A-FTS (INTAKE / EXHAUST)>COOLANT>ON-VEHICLE INSPECTION

OK:

No leaks.



Result:
Proceed to
OK
NG



OK

7.BLEED AIR

NG

6.REPAIR COOLANT LEAK
6.REPAIR COOLANT LEAK
a.

Repair any coolant leaks.


Result:
Proceed to
NEXT



NEXT

7.BLEED AIR
7.BLEED AIR
a.

Bleed the air and add coolant up to the FULL Line on the reservoir tank.

Click hereEngine / Hybrid System>V35A-FTS (INTAKE / EXHAUST)>COOLANT>REPLACEMENT


Result:
Proceed to
NEXT



NEXT

8.PERFORM ACTIVE TEST USING GTS (CONTROL THE INTERCOOLER WATER PUMP)
8.PERFORM ACTIVE TEST USING GTS (CONTROL THE INTERCOOLER WATER PUMP)
NOTICE:

Be sure to perform the inspection with the battery voltage at 11 V or more.


HINT:

If the battery voltage is low, the electric water pump assembly may stop operating.


a.

Read the Data List during 85% drive of the electric water pump.

Powertrain > Engine > Active Test
Active Test Display
Control the Intercooler Water Pump
Data List Display
Intercooler Water Pump Speed
50004 372 9 104
Standard:

In the Data List, the Electric Water Pump Speed is 4000 to 7000 rpm.



Result:
Proceed to
NEXT



NEXT

END