This DTC is stored when the blind spot monitor sensor RH (A) judges that there is a communication problem with the blind spot monitor sensor LH (B).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| U023387 | Lost Communication with Side Obstacle Detection Control Module "B" Missing Message | The blind spot monitor sensor RH (A) cannot receive signals from the blind spot monitor sensor LH (B) |
·
Blind spot monitor sensor LH (B)
·
Blind spot monitor sensor RH (A) |
Blind Spot Monitor "A" | A |
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Operating the ignition switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.
Check for DTCs.
| Result | Proceed to |
|---|---|
| U023387 is not output | A |
| U023387 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SENSOR>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| U023387 is not output | A |
| U023387 is output | B |
A
B