Home › Engine / Hybrid System › V35A-FTS (EMISSION CONTROL) › EMISSION CONTROL SYSTEM
RM38G0E _51 Engine / Hybrid System _101527 V35A-FTS EMISSION CONTROL _0470478 EMISSION CONTROL SYSTEM G

V35A-FTS EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A407763

To prevent injury due to contact with an operating fan and generator V belt or cooling fan, keep your hands and clothing away from the fan and generator V belt and cooling fans when working in the engine compartment with the engine running or the ignition switch on (IG).


PROCEDURE

Hide 1.VISUALLY CHECK HOSES, CONNECTIONS AND GASKETS

a.

Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

NOTICE:
·

Detachment or other problems with the engine oil level dipstick, oil filler cap assembly, ventilation hose or other components may cause the engine to run improperly.

·

Air suction caused by disconnections, looseness or cracks in any part of the air induction system between the throttle body with motor assembly and cylinder head sub-assembly will cause engine failure or engine malfunctions.



If any defects are found, replace parts as necessary.


Hide 2.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

CAUTION:

To prevent injury due to contact with an operating fan and generator V belt or cooling fan, keep your hands and clothing away from the fan and generator V belt and cooling fans when working in the engine compartment with the engine running or the ignition switch on (IG).


a.

Warm up the engine.


b.

Turn the ignition switch off.


c.

Connect the GTS to the DLC3.


d.
A477952

Slide the clip and disconnect the No. 2 fuel vapor feed hose from the purge VSV (duty vacuum switching valve).


e.

Start the engine.


f.

Turn the GTS on.


g.

Enter the following menus: Powertrain / Engine / Active Test / Activate the EVAP Purge VSV

Powertrain > Engine > Active Test
Tester Display
Activate the EVAP Purge VSV
50004 372 1

h.

Check that vacuum occurs at the purge VSV (duty vacuum switching valve) port.

If vacuum does not occur, check the following items.

·

Purge VSV (Duty Vacuum Switching Valve)

·

Clogging in the No. 2 fuel vapor feed hose that connects the intake manifold and purge VSV (duty vacuum switching valve)



i.

Exit Active Test mode.

If the result is not as specified, replace the purge VSV (duty vacuum switching valve), wire harness or ECM.


j.

Connect the No. 2 fuel vapor feed hose to the purge VSV (duty vacuum switching valve) and slide the hose clip to secure it.

Click hereEngine / Hybrid System>V35A-FTS (EMISSION CONTROL)>PURGE VALVE>INSTALLATION


k.

Enter the following menus: Powertrain / Engine / Data List / EVAP (Purge) VSV.

Powertrain > Engine > Data List
Tester Display
EVAP (Purge) VSV
50003 372 226

l.

Warm up the engine and drive the vehicle.


m.

Confirm that the purge VSV (duty vacuum switching valve) opens.

If the result is not as specified, replace the purge VSV (duty vacuum switching valve), wire harness or ECM.