| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | TAIL EXHAUST PIPE ASSEMBLY | 17430 | ( ) |
- | - |
| 2 | FRONT AND CENTER EXHAUST PIPE ASSEMBLY | - | ( ) |
- | - |
| 3 | EXHAUST PIPE DAMPER | 17581A | ( ) |
- | - |
| *1 | FRONT EXHAUST PIPE ASSEMBLY | *2 | CENTER EXHAUST PIPE ASSEMBLY |
| *3 | COMPRESSION SPRING | *4 | EXHAUST PIPE SUPPORT |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the exhaust pipe removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Wear protective gloves when removing the exhaust pipe.
The exhaust pipe is extremely hot immediately after the engine has stopped.
Confirm that the exhaust pipe has cooled down before removing it.
17430 1.REMOVE TAIL EXHAUST PIPE ASSEMBLY
|
|
2.REMOVE FRONT AND CENTER EXHAUST PIPE ASSEMBLY
|
|
17581A 3.REMOVE EXHAUST PIPE DAMPER
|
|