| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | EXHAUST PIPE DAMPER | 17581A | - | - | - |
| 2 | FRONT AND CENTER EXHAUST PIPE ASSEMBLY | - | ( ) |
- | - |
| 3 | TAIL EXHAUST PIPE ASSEMBLY | 17430 | ( ) |
- | - |
| 4 | INSPECT FOR EXHAUST GAS LEAK | - | - | - | ( ) |
| *1 | FRONT EXHAUST PIPE ASSEMBLY | *2 | CENTER EXHAUST PIPE ASSEMBLY |
| *3 | COMPRESSION SPRING | *4 | EXHAUST PIPE SUPPORT |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
17581A 1.INSTALL EXHAUST PIPE DAMPER
2.INSTALL FRONT AND CENTER EXHAUST PIPE ASSEMBLY
Install the center exhaust pipe assembly to the exhaust pipe support.
Install 3 new gaskets.
Do not reuse the gaskets.
Temporarily install the front exhaust pipe assembly to the center exhaust pipe assembly with 2 new bolts.
Temporarily install the front exhaust pipe assembly and center exhaust pipe assembly to the exhaust manifold sub-assembly RH and exhaust manifold sub-assembly LH with 4 new bolts.
Tighten the 6 bolts in the order shown in the illustration.
17430 3.INSTALL TAIL EXHAUST PIPE ASSEMBLY
Using a vernier caliper, measure the free length of the compression spring.
42 mm (1.65 in.)
If the free length is less than the minimum, replace the compression spring.
| *1 | Gasket | - | - |
| *a | Wooden Block | - | - |
Temporarily install a new gasket to the center exhaust pipe assembly.
Using a plastic-faced hammer and wooden block, tap in a new gasket until its surface is flush with center exhaust pipe assembly.
Be sure to install the gasket so that it faces the correct direction.
Do not reuse the gasket.
Do not damage the gasket.
When connecting the tail exhaust pipe assembly, do not push in the gasket with the tail exhaust pipe assembly.
Install the tail exhaust pipe assembly to the 4 exhaust pipe supports.
Connect the tail exhaust pipe assembly to the center exhaust pipe assembly with the 2 compression springs and 2 bolts.
4.INSPECT FOR EXHAUST GAS LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.
Perform "Inspection After Repair" after repairing an exhaust gas leak.
Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION