| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | STARTER YOKE ASSEMBLY | 28120 | - | - | - |
| 2 | MAGNET STARTER SWITCH ASSEMBLY | 28150 | ( ) |
- | - |
| 3 | STARTER BRUSH HOLDER ASSEMBLY | 28140 | ( ) |
- | - |
| 4 | STARTER ARMATURE ASSEMBLY | 28160 | - | - | - |
| *1 | STARTER COMMUTATOR END FRAME | *2 | SPRING |
| *3 | STARTER DRIVE HOUSING | *4 | STARTER CLUTCH |
| *5 | RETURN SPRING | *6 | IDLE GEAR |
| *7 | RETAINER | *8 | CLUTCH ROLLER |
| *9 | STEEL BALL | - | - |
| ● | Non-reusable part | - | - |
28120 1.REMOVE STARTER YOKE ASSEMBLY
Remove the nut and disconnect the lead wire from terminal C.
Remove the 2 bolts.
Pull out the starter yoke assembly and commutator end frame together with the starter armature assembly.
Remove the O-ring from the starter yoke assembly.
28150 2.REMOVE MAGNET STARTER SWITCH ASSEMBLY
| *1 | Starter Drive Housing | *2 | Starter Clutch |
| *3 | Return Spring | *4 | Idle Gear |
| *5 | Retainer | *6 | Clutch Roller |
| *1 | Magnet Hand | - | - |
Using a magnet hand, remove the steel ball from the starter clutch hole.
28140 3.REMOVE STARTER BRUSH HOLDER ASSEMBLY
Remove the 2 screws, and then remove the commutator end frame from the starter yoke assembly.
While holding down the lead wire, remove the commutator end frame.
Remove the O-ring from the starter yoke assembly.
Disconnect the 4 brushes from the starter brush holder assembly.
1. Using a screwdriver, hold back the brush spring.
2. Disconnect the brush from the starter brush holder assembly.
Remove the starter brush holder assembly.
28160 4.REMOVE STARTER ARMATURE ASSEMBLY