This circuit is the power source circuit to operate the parking assist ECU. The parking assist ECU controls the multi-terrain monitor system.
Inspect the fuse for circuits related to this system before performing the following procedure.
If the parking assist ECU does not operate due to a power source problem, other system DTCs may be stored due to a CAN communication interruption.
Disconnect the I60 parking assist ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I60)Location & Routingewd_type=routing;type=c;code=I60 |
||
| I60-4 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(I60)Location & Routingewd_type=routing;type=c;code=I60 |
||
| I60-1 (+B) - I60-4 (GND) | Always | 11 to 14 V |
| I60-2 (ACC) - I60-4 (GND) | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V | |
| I60-3 (IG) - I60-4 (GND) | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |
| Proceed to |
|---|
| OK |
| NG |
OK
NG